Cardioid 18-inch Shure Microflex MX400D Series microphone is miniature electret condenser gooseneck microphones with a desktop base and an attached 10ft (3m) cable. The desktop base allows these microphones to be used in multipurpose rooms where quick set-up is required, or where permanent installation is impractical. The Microflex Gooseneck microphones bring a whole new meaning to the word flexible. Beyond their fully adjustable goosenecks lies a new level of flexibility the new Microflex interchangeable condenser microphone cartridge. Designed for easy replacement and available in cardioid polar pattern, the interchangeable cartridge offers wide frequency response and accurate sound reproduction for a broad variety of applications, such as houses of worship, courtrooms and conference centers. Plus, the condenser cartridges fit every model in the new Microflex product line for enhanced convenience and consistent sound.
Recommended for general sound reinforcement applications
Wide dynamic range and frequency response for
accurate sound reproduction across the audio spectrum
Balanced, transformerless output for increased immunity to noise over long cable runs
Programmable on/off switch and LED on/off indicator
Logic input and output terminals for remote control or use with automatic microphone mixers
Snap-fit foam windscreen
Desktop base with 10ft cable
Polar/Pickup Pattern - Cardiod
Microphone Type - Mini Condenser
Spec Sheet available - Yes
Operating Temperature (Maximum):
135 F
Operating Temperature (Minimum):
0 F
Cable Length:
10 ft
Impedance:
150 ohm
Maximum SPL (Sound Pressure Level):
123 dB
Sensitivity:
-33.50 dB
Signal to Noise Ratio:
65 dB
DC Voltage:
52 Volts
Product Weight:
1.81 lbs
Shipping Weight:
3.62 lbs
Polar Pattern:
Cardioid
Output Impedance:
180 ohms actual (rated at 150 ohms) at 1000Hz
Open Circuit Sensitivity:
-33.5dB (21.1mV) (at 1kHz, ref. 1 V/Pascal), All settings –12dB at 0 gain, 1 Pascal = 94dB SPL
Maximum SPL:
123 dB (1kHz at 1% THD, 1 kohms load), All settings +6dB at 0 gain
Equivalent Output Noise:
29 dB SPL (A-weighted)
Signal to Noise:
65 dB (referenced at 94dB SPL)
Dynamic Range at 1k ohms Load:
94 dB (100dB at 0 gain)
Pickup Angle:
130 degree (–3 dB)
Common Mode Rejection:
45 dB (minimum)
Mute Switch Attenuation:
50 dB (minimum)
Preamplifier Output Clipping Level:
–6dBV (0.5V), –12dB at 0 gain (1% THD)
Polarity:
Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output connector
Power Requirements:
11 to 52V DC phantom, 2mA
Relative Humidity:
0 to 95 %
Cable Overall diameter:
0.165 in (0.6 mm)
Certification:
Eligible to bear CE Marking, Conforms to European EMC Directive 89/336/EEC, Meets applicable tests and performance criteria in European Standard EN55103 (1996) parts 1 and 2, for residential (E1) and light industrial (E2) environments