The INT-TXO is the central element in the INTEGRUS system that allows INTEGRUS to interact with the DICENTIS Conference System. The INT-TXO modulates the signals into carrier waves and transmits them to the radiators in the room. When connected to a DICENTIS system, the Transmitter OMNEO is fully controlled by DICENTIS and does not require any configuration.

Functions 

• The Transmitter OMNEO can be connected to, and controlled by, a DICENTIS system. In this setup, it can also be powered through a DICENTIS cable, including the RSTP functionality

• The INT-TXO can be switched to the slave mode to act as a repeater of another INT-TXO. In this case, the signal is received through the coaxial input and synchronizes with the master INT-TXO. The slave mode is enabled through a switch on the rear of the device

Controls and indicators

• System and radiator status visible at the front of the device

• Two LEDs are located near each Ethernet connector 

Interconnections

• Different power options that do not influence each other:

– DC wall adapter

– DICENTIS

– PoE

One BNC connector for accepting a HF signal from another transmitter. The INT-TXO includes a switch to set the transmitter as a slave to another transmitter with synchronized audio

• Six BNC connectors for output of HF signal to up to 30 radiators

• Power through the DICENTIS system cables

• Two DICENTIS connectors compatible with RJ45 connectors for:

– Loop through in a DICENTIS system, including RSTP

– Powering through PoE.