Network Equipment : Card Cages : Evertz - 7700GPI

VistaLINK® General Purpose Interface Module

Model: 7700GPI

20 opto-isolated General Purpose Interface inputs (GPI)
Enabled GPI inputs/alerts translated and reported to Network Management System (NMS) user interface via SNMP
Selectable +5V or +12V supply for driving GPI over longer cable runs
3 relay closure General Purpose Interface outputs (GPO)
GPI/GPO easily accessed through pin-headers (2x6 Phoenix Terminal Blocks) on rear plate

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Documents

The 7700GPI VistaLINK® General Purpose Interface module links third-party equipment and Evertz's VistaLINK® Network Management System (NMS). Third-party equipment with fault alarming capabilities through General Purpose Interface outputs (GPO) can communicate fault alarm conditions to the VistaLINK® application software through this GPO to SNMP translator thereby extending fault monitoring capabilities across the broadcast network.

20 opto-isolated General Purpose Interface inputs (GPI)
Enabled GPI inputs/alerts translated and reported to Network Management System (NMS) user interface via SNMP
Selectable +5V or +12V supply for driving GPI over longer cable runs
3 relay closure General Purpose Interface outputs (GPO)
GPI/GPO easily accessed through pin-headers (2x6 Phoenix Terminal Blocks) on rear plate
1 LTC input for module synchronization of fault alarms to facility time
Modular, conveniently fits into 7800FR 3RU frame
Module status LED and 20 GPI LEDs for simple GPI input diagnositics
Frame status trigger
Jumper-configurable RS-232/RS-422 input serial COM port for serial protocol interface translation
VistaLINK® capable for remote monitoring and control via SNMP (using VistaLINK® PRO) when installed in 7800FR frame with a 7700FC VistaLINK® Frame Controller

Spec Sheet available - Yes

Number of Card Slots: 1
Number of Inputs: 20
Number of Outputs: 3
Rack Units (Height): 3
Active Power: 6 Watt
DC Voltage: 12 Volts
Type: Opto-isolated, active low with jumper selectable +5V or +12V supplied voltage
Connector: Phoenix Terminal Block (2 x 6)
Signal Level: Jumper selectable +5V or +12V
Number of Inputs: 1 ± pair
Level: 100mV p-p
Number of Ports: 1 RS-232 or 1 RS-422 (jumper selectable)
Baud Rate: Up to 1Mbaud

VistaLINK® General Purpose Interface Module 66 kb - Data Sheet

Project List

Products

VistaLINK® General Purpose Interface Module

Model: 7700GPI

Contact

Solutions

Insights

About

Privacy Policy

Terms & Conditions

Copyright © 2025 A-V Services, Inc. | All Rights Reserved | Powered By Chatter Creative