Racks : Chassis : RDL, Radio Design Labs - STS-RF1

Shielded Chassis for STICK-ON Module

Model: STS-RF1

Shielded chassis for mounting one STICK-ON module
Radio frequency filters on each signal conductor
Wiring Connections on Detachable Terminal Block
Mounts to any flat surface
Ideal for installations where excessive interference is anticipated

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Related Products

Documents

The STS-RF1 is an aluminum chassis for mounting one STICK-ON module. The chassis provides shielding to suppress radio frequency interference. External audio, power supply or control signals are each connected to the STICK-ON module through a specialized radio frequency suppression filter. External wiring connects to a detachable terminal block. Cable shields are connected to a large grounding screw above the terminal block. The cover is equipped with tabs to securely mount the chassis to any flat surface.

The STS-RF1 is recommended for use in installations where excessive rf interference levels are anticipated from sources such as WIFI transmitters.

Shielded chassis for mounting one STICK-ON module
Radio frequency filters on each signal conductor
Wiring Connections on Detachable Terminal Block
Mounts to any flat surface
Ideal for installations where excessive interference is anticipated

Spec Sheet available - Yes

Depth: 4.38 in
Height: 1.59 in
Width: 5.64 in
Package Type: Cardboard Box
Compatibility: All STICK-ON modules except STICK-ON power amplifiers
Tariff code: 8543.70.9960

ST-ACR1 - Line-Level Controlled Relay

ST-ACR1M - Microphone Level Audio Controlled Relay

ST-ACR2 - 5 to 50sec Delay Line-Level Controlled Relay

ST-CL2 - Line Level Compressor/Limiter

ST-CX2 - Two Band Active Line-level Crossover

ST-DA3 - Line Level Distribution Amplifier - 1x3

ST-EQ3 - 3 Band Equalizer - Line Level

ST-FS6 - Ferrite Suppressor / RF Filter

ST-GCA3 - Gain Control Amplifier - Line Level

ST-GLA1 - Gated Line Amplifier - Noise Gate

ST-GSP1 - Gated Speech Preamplifier - Mic to Line

ST-HP3 - 300 Hz and 500 Hz High Pass Filter

ST-IC1 - Intercom Amplifier

ST-LCR1 - Logic Controlled Relay - Momentary

ST-LCR1H - High Power Logic Controlled Relay - 8 A

ST-LCR2 - Logic Controlled Relay - Latching

ST-LCR3 - Logic Controlled Relay - Dual Alternate Pulse

ST-LEQ1 - Loudness Equalizer - Use with VCA

ST-MA2 - Muting Monitor Amplifier - 2 Watt

ST-MPA24 - 24V Adjustable Dual Microphone Phantom Adapter

ST-MPA48 - 48V Fixed Dual Microphone Phantom Adapter

ST-MX2 - 2 Mic or Line Input Mixer - Mic and Line Out

ST-MX3 - 3 Line Input Mixer - Line Out

ST-NG1 - White and Pink Noise Generator

ST-OSC2A - Audio Oscillator - 1kHz and 10 kHz

ST-OSC2B - Audio Oscillator - 100 Hz and 400 Hz

ST-PD5U - Power Distributor - Switching - (PS-24U2/A)

ST-PH1 - Stereo Phono Preamplifier

ST-RG1 - Ramp Generator - 0 to 10 Vdc Output

ST-RX2 - Audio Routing Switcher - 1x2

ST-SH2 - Stereo Headphone Amplifier

ST-SSR1 - Line-Level Audio Switch - 2x1

ST-SX4 - Unbalanced Audio Switcher - 4x1

ST-TC1 - Telephone System Coupler - CO Line Simulator

ST-UBA2 - Unbalanced to Balanced Amplifier - 2 channel

ST-UMX3 - Universal Audio Mixer - 3 Mic or Line x 1 Mic or Line

ST-VCA3 - Voltage Controlled Amplifier

ST-VOX1 - Voice Operated Relay

ST-VP1 - Voice-Over / Paging Module - Manual

ST-VP2 - Automatic Ducking Module

STA-1 - Dual Bal/Unbal Line Amp: -12 to 20 dB Gain

STA-1M - Audio Line Amplifier - Mono

STD-10K - Passive Audio Divider/Combiner - 10 k ohm

STD-150 - Passive Audio Divider/Combiner - 150 ohm

STD-600 - Passive Audio Divider/Combiner - 600 ohm

STM-2 - Adjustable Gain Mic Preamp - 35 to 65 dB Gain

STM-2X - Switched Mic Preamp - 35 to 65 dB Gain

STM-3 - High Gain Mic Preamp - 35 to 75 dB Gain

STM-DA3 - Mic Level Distribution Amplifier - 1x3

STM-LDA3 - Studio Quality Mic Preamp with phantom - 3 Line Outputs

STP-1 - Universal Audio Attenuators - 2 Channel

Shielded Chassis 1678373 kb - Data Sheet

Project List

Suggested Products

Chassis, Empty, for 2 Boards + with internal PSU with preparation for redundant PSU

by IHSE USA, LLC

Universal 1U Rack Mount Chassis for 2 DigitaLinx or DigiIP Devices

by Liberty AV Solutions

Chassis, Empty, 6 slots, 1PS, rear mount power, 7A, 100-240VAC, redundancy preparation

by IHSE USA, LLC

Products

Shielded Chassis for STICK-ON Module

Model: STS-RF1

Suggested Products

Contact

Solutions

Insights

About

Privacy Policy

Terms & Conditions

Copyright © 2025 A-V Services, Inc. | All Rights Reserved | Powered By Chatter Creative